Sony MFM-HT75W Mode D'emploi page 824

Power saving function
This display meets the power-saving guidelines set by VESA and
NUTEK. If the display is connected to a computer or video
graphics board that is DPMS (Display Power Management
Standard) for Analog input/DMPM (DVI Digital Monitor Power
management) for Digital input compliant, the display will
automatically reduce power consumption as shown below.
MFM-HT75W
Power mode Power consumption
normal 68 W (max.)
operation
active off* 1.2 W (max.)
(deep sleep)**
MFM-HT95
Power mode Power consumption
normal 74 W (max.)
operation
active off* 1.2 W (max.)
(deep sleep)**
* When your computer enters the "active off" mode, the input signal is
cut and "No Input Signal" appears on the screen. After 5 seconds, the
display enters the power saving mode.
** "Deep sleep" is a power saving mode defined by the Environmental
Protection Agency.
Tip
When the display is in the standby mode or the Sleep timer is activated,
the 1 (power) indicator lights up in red.
Setting the Picture Mode
You can select the Picture Mode using the
in the "Picture" menu.
When you select "Auto," the display automatically adjusts the
screen brightness according to the brightness of the surroundings
(Automatic brightness adjustment function). For more
information, see "Automatic brightness adjustment function
(light sensor)".
For details on using the "Mode" menu, see page 18.
For details on using the
(power)
1
Press the
indicator
Each time you press the
green
follows.
orange
(power)
1
indicator
green
orange
Each indication appears on the screen and Picture Mode is
changed. The menu automatically disappears after about 5
seconds.
Automatic brightness adjustment
function
This display is provided with a feature to automatically adjust the
screen brightness according to the brightness of the surroundings.
The brightness of the screen is set to the most appropriate level by
setting the Picture Mode to "Auto" with the
in the "Picture" menu. (When you select the input from PC 1 or
PC 2, "Movie" is selected as the default. When you select the
input from VIDEO 1, VIDEO 2, or TV, "Vivid" is selected as the
default.)
Also, when you set the Picture Mode to "Auto" with the
button, the adjustment bar is displayed. You can adjust the bar
with the M/m buttons. Screen brightness changes according to
the level you set.
button, see below.
button repeatedly.
button, the Picture Mode changes as
P C 1 / P C 2 T V / V I D E O 1 / V I D E O 2
G a m e
M o v i e
P C
Au t o
1 0 0 1 0 0
(light sensor)
button or "Mode"
V i v i d
S t a n d a r d
GB
E C O
Au t o
button or "Mode"
31