Watching The Tv - Sony MFM-HT75W Mode D'emploi

Watching the TV

Setting the TV channels
To watch TV programs, you need to run "Auto Program" to set up
your channels.
Perform the following "Auto Program" procedure before you
watch TV programs for the first time.
For details on the use of the menu and buttons, see "Navigating
the menu" on page 15.
1 Press the MENU button.
2 Press the M/m buttons to select
press the OK button.
The "Channel" menu appears on the screen.
3 Press the M/m buttons to select "Auto Program"
and press the OK button.
The "Auto Program" menu appears on the screen.
4 Press the M/m buttons to select "OK" and press the
OK button.
The display starts scanning and preparing channels
automatically.
Channel number and on-screen message appear.
5 Press the MENU button to exit the menu screen after
Auto Program is completed.
Changing the TV channel
Press the 0-9 buttons to input a channel number.
The channel changes after 3 seconds. Press the ENT (enter) button
to select immediately.
Use the CH +/– buttons to scan through the channels.
Tip
When you press and hold the CH + or – button, the channel number will
change rapidly.
14
(Channel) and
or
Skipping unnecessary channels
You can skip unnecessary channels when selecting channels
using the CH +/– button.
1 Press the MENU button.
2 Press the M/m buttons to select
press the OK button.
The "Channel" menu appears on the screen.
3 Press the M/m buttons to select "Channel Skip/
Add" and press the OK button.
The "Channel Skip/Add" menu appears on the screen.
4 Press the M/m buttons to select the channel you
want to skip and press the OK button.
Tip
To scroll through the list, press and hold the M/m buttons.
5 Press the M/m buttons to select "Skip" and press
the OK button.
If you want to restore skipped channel, select "Add."
6 Press the MENU button to exit the menu screen.
Choosing between cable and UHF/
VHF
To set the UHF/VHF channels, you need to set the "Cable" menu
to "Off" by following the instructions below.
1 Press the MENU button.
2 Press the M/m buttons to select
press the OK button.
The "Channel" menu appears on the screen.
3 Press the M/m buttons to select "Cable" and press
the OK button.
The "Cable" menu appears on the screen.
4 Press the M/ms buttons to select the desired mode
and press the OK button.
• On: The cable TV channels can be set.
• Off: The UHF/VHF channels can be set.
Note
You cannot set and receive cable TV channels and UHF/VHF channels at
the same time.
(Channel) and
(Channel) and