Sony MFM-HT75W Mode D'emploi page 555

Specifications
LCD panel
Panel type: a-Si TFT Active Matrix
Screen size:
17 inch (43 cm) (MFM-HT75W)
19 inch (48 cm) (MFM-HT95)
Display resolution:
MFM-HT75W
Horizontal: Max. 1280 dots
Vertical: Max. 768 lines
MFM-HT95
Horizontal: Max. 1280 dots
Vertical: Max. 1024 lines
Signal input
PC 1
Signal format:
Digital RGB (DVI-D) (TMDS Single link)
Operating frequency:
MFM-HT75W
Horizontal: 28–48 kHz
Vertical: 60 Hz
MFM-HT95
Horizontal: 28–64 kHz
Vertical: 60 Hz
Audio:
Stereo mini jack, 500 mVrms (100% modulation)
PC 2
Signal format:
Analog RGB (HD-15D-sub)
Operating frequency:
MFM-HT75W
Horizontal: 28–69 kHz
Vertical: 48–85 Hz
MFM-HT95
Horizontal: 28–86 kHz
Vertical: 48–85 Hz (resolution<1280 × 1024)
48–75 Hz (resolution=1280 × 1024)
Signal levels:
RGB signal: 0.7 Vp-p, 75 Ω, positive
SYNC signal:
TTL level, 2.2 kΩ, positive or negative (Separate
horizontal and vertical, or composite sync)
0.3 Vp-p, 75 Ω, negative (Sync on green)
Audio:
Stereo mini jack, 500 mVrms (100% modulation)
TV
TV System:
PAL, SECAM, NTSC (I, D/K, B/G, M)
Stereo/Bilingual system:
NICAM system for B/G, I, D/K
A2 System for B/G
Channel coverage:
B/G
VHF: E2 to E12 / UHF: E21 to E69 / CATV: S01
to S03, S1 to S41
VHF: 0 to 12, 5A, 9A / UHF: 28 to 69 / CATV:
S01 to S03, S1 to S41 (Australia only)
VHF: 1 to 11 / UHF: 21 to 69 / CATV: S01 to
S03, S1 to S41 (New Zealand only)
I
UHF: B21 to B68 / CATV : S01 to S03, S1 to S41
38
D/K
VHF: C1 to C12, R1 to R12 / UHF: C13 to C57,
R21 to R60
CATV: S01 to S03, S1 to S41, Z1 to Z39
M
VHF: A2 to A13 / UHF: A14 to A79
CATV: A-8 to A-2, A to W+4, W+6 to W+84
Antenna:
75-ohm external terminal for VHF/UHF
VIDEO 1
Signal standard:
Component video (Y, P
Y: 1.0 Vp-p, 75-ohm unbalanced, sync negative
: 0.7 Vp-p, 75 Ω
P
B
: 0.7 Vp-p, 75 Ω
P
R
Signal format:
480i (525i), 480p (525p), 576i (625i), 576p (625p),
720p (750p), 1080i (1125i)
Audio:
Phono jack (stereo), 500 mVrms (100% modulation)
VIDEO 2
Signal standard:
S-Video (4-pin mini DIN)
Y: 1.0 Vp-p, 75-ohm unbalanced, sync negative
C: 0.286 Vp-p (Burst signal), 75 Ω
Composite video (Phono jack)
1.0 Vp-p, 75-ohm unbalanced, sync negative
Video format: NTSC, PAL, SECAM
Audio:
Phono jack (stereo), 500 mVrms (100% modulation)
Plug & Play
VESA, DDC2B
Speaker output
Max. 3 W × 2 +5 W
Headphones output
Stereo minijack
Power requirements
100–240 V AC, 50–60 Hz
Max. 1.3 A (MFM-HT75W)
Max. 1.4 A (MFM-HT95)
Power consumption
In use (Max.): 68 W (MFM-HT75W)/74 W (MFM-HT95)
In standby (Max.): 1.2 W
Operating temperature
0–35 C
°
Dimensions (width/height/depth)
Display (upright):
MFM-HT75W
Approx. 450.2 × 353.5 × 176 mm
MFM-HT95
Approx. 466.6 × 437 × 185 mm
Mass
MFM-HT75W
Approx. 6.3 kg
MFM-HT95
Approx. 7.8 kg
Accessories
See page 9.
Design and specifications are subject to change without notice.
, P ) (Phono jack)
B R