La San Marco NEW 105 TOUCH Emploi Et Entretien page 67

if, after programming a volumetric dose, the same is no longer dispensed, it is possible that the dosage func-
tion, for some reason, did not receive the pulses from the volumetric meter and thus programmed a dose
amounting to 0 pulses.
Possible causes to verify: volumetric meter incorrectly connected, volumetric meter mixed up with that of
another unit, inoperational water circuit.
PROGRAMMING TeA DOSeS
The quantities relating to the tea doses can be modified and stored (by timed control) by following the pro-
cedure below:
 In IDLe-ON status, press the K5GRx (1..3) key and keep pressing it for 10 seconds; make sure that the
lighting of the LeDs l5GRx (1..3) switches from fixed to flashing.
The display shows
 Within 30 seconds (time-out to quit the programming phase), press the K6GRx key combined with the tea
dose. The LeD relating to the K6GRx key will flash.
The eVTeA actuator is enabled for the entire duration of tea dose programming.
 When the quantity of tea with which the dose is to be programmed is achieved, press the K6GRx key used
previously to interrupt product dispensing again, with the consequent de-energising of the eVTeA.
The new time for the tea dose duration is stored.
• To proceed with programming the other tea doses, (if the programming time-out of 30 seconds is not ex-
ceeded and you entered the programming environment from unit 1 by pressing the K5GR1 key), repeat in
sequence points  and .
• If the time-out (30 seconds) is triggered during the programming phase, to proceed with its performance,
you will need to repeat the entire sequence described in points ,  and .
iMPoRtant: the programming of the tea dose made on the FiRSt Unit is nEVER automatically
transferred to all the other units. to program the tea dose on the remaining units, simply repeat the
operations described in pints ,  and .
Note:
when programming a Tea dose, the units remain disabled, along with the dispensing of other teas.
PROGRAMMING FOR STeAM TeMPeRATURe SIMULATION
The temperature at which the eVVAP should be deactivated can be modified and stored for simulation by
following the procedure below.
 In IDLe-ON status, press the K5GR1 (1..3) key and keep pressing it for 10 seconds; make sure that the
lighting of the LeDs l5GRx (1..3) switches from fixed to flashing.
The display shows
 Within 30 seconds (time-out to quit the programming phase), press the K6GRx key combined with the
steam.
The eVVAP actuator is enabled for the entire duration of programming.
 When the desired temperature is reached, press the K6GR1 key used previously to interrupt the steam
dispensing again, with the consequent de-energising of eVVAP.
The new temperature value for steam (steam spout) is stored
• if the time-out (30 seconds) is triggered during the programming phase, to proceed with its perfor-
mance, you will need to repeat the entire sequence described in points ,  and .
66
Doses setting
Select within30s
Doses setting
Select within30s