Using The Manual; Installation - Safety Instructions - La San Marco NEW 105 TOUCH Emploi Et Entretien

1. Safety instructions
Before using the machine, carefully read all of the instructions contained in this machine.
1.1 Using the manual
This manual contains all information required for the installation, use and maintenance of the
coffee machine.
This manual is an integral part of the machine; always keep it intact together with the appliance.
The manual can be downloaded from the website (www.lasanmarco.com) in the reserved area
"Documentation commercial and technical ", or on request in pdf format on cd.
1.2 Safety instructions
Do not operate the machine or carry out routine maintenance before reading this manual. La San
Marco S.p.A. reserves the right to make any technical changes on the machine considered neces-
sary without advance notice.
1.2.1 Installation - Safety instructions
• The installation must be carried out by authorized La San Marco technical personnel.
• This machine must be installed only in places where its use and its maintenance are made by trained personnel.
• The coffee machine is delivered in a suitable packing. The packing contains the machine and its acces-
sories:
– filter cups with filter restraint ring
– filters for filter cups (single and double doses)
– blind filter for filter cup
– spouts for filter cups (single and double doses)
– press for ground coffee
– rubber tube with stainless steel mesh for water connection (water circuit - water softener)
– rubber drain hose with steel coil for water drain
– 3/8" nipples for hose connection to water supply tube
– cleaning brush for serving units
Inclined cup grip protection
–
• The user manual and the conformity declaration. After opening the packing, check the proper condition of
the coffee machine and its components. In case of doubt, do not use the appliance, and contact La San
Marco S.p.A.
• All of the packaging must be carefully conserved in case the machine needs to be transported in the future.
• The machine should be placed on a perfectly horizontal plane at a height of not less than 1000 mm above
the floor. The horizontal plane must be sufficiently sturdy to support the weight of the machine, with a suf-
ficient clearance around it to dissipate the heat generated during its operation.
• The device must be connected to the local water mains using a flexible pipe fitting in compliance with na-
tional standards, if these are applicable. Furthermore, the equipment must be installed with suitable "reflux
protection" in order to comply with the applicable national and local regulations.
• Connect the appliance to the water main supply using only the equipment provided.
• Do not install the espresso coffee machine in places where cleaning is likely to be carried out with jets of water.
• For safety against hazards related to electrical currents, keep the machine away from sinks, tubs, aquari-
ums, taps, and areas that are wet or where water may splash.
• The machine creates heat. Therefore it needs to be placed in a room that is sufficiently ventilated to ensure
heat dissipation.
• Keep the machine away from sources of direct heat.
• Make sure that the voltage of the power socket does not differ from that indicated on the technical data
and on the identification tag on the machine. If the voltage is different, do not connect the machine. This
may be dangerous and may damage the unit.
• The electrical connection must be carried out in accordance with the regulations of the country of installation.
46