Burkert TopControl Basic Guide Rapide page 18

Output signals to the control center (e.g. PLC; for analog
output option only)
Terminal Configuration
2 Analogue position
feedback +
3 Analogue position
feedback GND
Tab. 5: Assignment of screw-type terminals - output signals to the control
center - option
Connection housing
Fig. 13: Position of the seal in the body casing
→
Check that the seal is correctly positioned in the body casing.
18
External circuit / signal level
2
+ (0/4 ... 24 mA)
3 GND
Body casing
Seal
Body casing
english
Type 8694
Electricalinstallation
NOTE!
Breakage of the pneumatic connection pieces due to rota-
tional impact.
▶ When unscrewing and screwing in the body casing, do not hold
the actuator of the process valve but the connection housing.
Damage or malfunction due to penetration of dirt and humidity.
To ensure degree of protection IP65 / IP67:
▶ Tighten the union nut on the cable gland according to the cable
size or dummy plugs used (approx. 1.5 Nm).
▶ Screw the body casing in all the way.
→
Tighten union nut on the cable gland (torque approx. 1.5 Nm).
→
Close the device (assembly tool: 674077
When the supply voltage is applied, the positioner is operating.
→
Actuate the automatic adjustment of the positioner, as described
in the chapter entitled "10.2 Automatic adjustment X.TUNE".
The assembly tool (674077) is available from your Bürkert sales office.
2)
2) ).