Electrical Installation As Interface; Connection With Circular Plug-In Connector M12 X 1, 4-Pole, Male; Connection With Multi-Pole Cable And Ribbon Cable Terminal - Burkert TopControl Basic Guide Rapide

9.3

Electrical installation AS Interface

A detailed description of the bus communication can be
found in the operating instructions Type 8694.
9.3.1 Connection with circular plug-in
connector M12 x 1, 4-pole, male
Connector views
The views show the image from the front looking at the pins, the
solder connections are behind them.
Pin 4:
NC
Pin 1:
Bus +
Fig. 15: Bus connection without external supply voltage
Pin 4:
24 V +
Pin 1:
Bus +
Fig. 16: Bus connection with external supply voltage (optional)
20
Pin 3:
Bus –
Pin 2:
NC
Pin 3:
Bus –
Pin 2:
GND
english
Type 8694
Electricalinstallation
Bus connection without external / with external supply voltage
Pin Designation Configuration
1 Bus + AS Interface bus line +
NC or GND not used or external supply voltage –
2
(optional) (optional)
3 Bus – AS Interface bus line –
NC or 24 V + not used or external supply voltage +
4
(optional) (optional)
Tab. 9: Pin assignment of circular plug-in connector for AS Interface
When the supply voltage is applied, the positioner is operating.
→
Actuate the automatic adjustment of the positioner, as described
in the chapter entitled "10.2 Automatic adjustment X.TUNE".
9.3.2 Connection with multi-pole cable and
ribbon cable terminal
As an alternative to the bus connection model with 4-pole circular
plug, there is the positioner with multi-pole cable (M12 circular plug)
and ribbon cable terminal. The wiring diagram of the circular plug cor-
responds to the bus connection of the M12 4-pole circular plug and
can easily be connected to the ribbon cable terminal.
The bus line may have a maximum length of 100 m. When
designing the system, consider the length of the cable which
is fed directly to the positioner for the maximum bus line length
(see example calculation in the operating instructions).