Operation Of The Model Helicopter; Charging The Flight Battery - Reely 1527787 Notice D'emploi

10. Operation of the Model Helicopter

a) Charging the Flight Battery
The flight battery installed in the helicopter is only charged via the transmitter. The charge time is approx. 30 to 50
minutes, depending on remaining flight battery charge and the condition of the transmitter batteries.
The charging connection of the helicopter (1) is at the bot-
tom of the model, between the landing skids.
For charging, the remote control transmitter and the heli-
copter must be switched off.
The on/off switch of the helicopter (2) is located by the
charging connection and must be in the "OFF" position.
Put the helicopter onto the remote control transmitter so
that the charge connection of the model interlocks with
secure contact with the charge socket of the transmitter.
The landing skids of the helicopter then must rest in the
cut-outs of the transmitter (also see figure 1, item 5).
When the contact is correct, a blue charging control LED
(3) will light up in the model helicopter to display that
charging is underway.
When the charge control LED goes out, charging is com-
pleted. The model helicopter must be removed from the
transmitter.
Attention!
Never leave the model helicopter unsupervised and disconnect it from the transmitter after charging is
complete.
Use only normal batteries for the transmitter. Do not use rechargeable batteries! The rechargeable battery
of the helicopter otherwise cannot be or can only be insufficiently charged due to the too low voltage in the
transmitter (batteries= 1.5 V/cell, rechargeable batteries = 1.2 V/cell)! The flight duration will be very short
in this case.
All manuals and user guides at all-guides.com
Figure 4
29