Tips For Flush Mounting - De Dietrich DTG 1138 Serie Guide D'installation Et D'utilisation

EN 2 / INSTALLING YOUR APPLIANCE

• TIPS FOR FLUSH MOUNTING

Mounting bracket
Fig. 01
A
A
A
Fig. 02
Fixing holes
A
Min 40 cm 2
Unit
Screw
4 fixing holes
A
Min 4 mm
Fig. 03
40
— If you wish, you can immobilise the hob
using the four mounting brackets delivered
with a screw (Fig. 02) to attach them to the
four corners of the housing. You must use the
holes provided for this purpose, according
to the diagram above (Fig. 01) .
— Tighten the screws until the fixing bracket
starts to pull out of shape.
Do not use a power screwdriver.
— Place your hob in the opening of the
support cabinet, carefully pulling the table
towards you.
— Reposition the pan supports, burner covers
and burner heads.
— Connect the hob's power cable to your
kitchen's electricity supply (see "Electric
connection" section).
FLUSH FITTING ABOVE A UNIT
WITH DOOR OR DRAWER
Fitting your hob above an oven requires the
oven to be low mounted.
It is recommended that the hob not be in-
stalled above an oven if the oven's ventilation
is not frontwards.
Create an air vent in the partition to the right
or left of the oven, of at least 40 cm².
Note
— The hob's heat-safety features prevent
it being used while it is in pyrolysis mode.