De Dietrich DTG 1138 Serie Guide D'installation Et D'utilisation page 44

EN 2 / INSTALLING YOUR APPLIANCE
Gas supplied by tank or
•
cylinder (butane/propane)
For your safety, you must choose from the
three following connection options:
— Use rigid copper pipe
mechanical connectors (G1/2 gas standard
mark). Connect directly to the elbow joint
fitted on the appliance.
— Use a flexible metal hose (stainless steel)
with screw-on mechanical connectors
(compliant with the NF D 36-125 standard)
with an unlimited guarantee (Fig. 01).
— Use a reinforced rubber hose with screw-
on mechanical connectors (compliant with
the NF D 36-112 standard) with a 10-year
guarantee (Fig. 02).
In an existing system, a flexible pipe fitted
with hose clips
XP D 36-110 standard) with a 5-year guarantee
A
Sealing washer (not provided)
B
Adaptor (not provided)
C Hose clip (not provided)
with screw-on
(compliant with
may be used. In this case an adaptor must be
used and a sealing washer must be inserted
between the adaptor and the elbow joint
(Fig. 03).
Tip
You can obtain the adaptor and the sealing
washer from your After-Sales Service
Department.
Note
Screw on the adaptor with a torque
not exceeding 25 N.m.
Q @
the
Fig. 01
@ Q
Note
Flexible pipes and hoses with a
limited guarantee should be no more than
2 metres long and must be accessible along
their entire length. They must be replaced
before the end of their guarantee (indicated
on the pipe). Whatever type of connection is
chosen, after installing the hob use soapy
water to ensure that the connection is
airtight.
In France, you must use a hose or a pipe
bearing the stamp NF Gaz.
44
Fig. 02 Fig. 03
A
B
C