Maintaining Your Appliance - De Dietrich DTG 1138 Serie Guide D'installation Et D'utilisation

EN 4 / DAILY CARE OF YOUR APPLIANCE
•

MAINTAINING YOUR APPLIANCE

MAINTENANCE......
The spark igniters
and injectors
The pan supports
and gas burners
The glass top
Note
- Never clean your appliance while it is in use. Set all the controls to zero.
If a crack appears in the surface of the glass, disconnect your appliance from the power
supply to avoid electric shock. Contact the After-Sales Service department.
Tips
— We recommend cleaning the hob fittings by hand rather than in a dishwasher.
— Do not use an abrasive sponge to clean your hob.
— Do not use a steam cleaner.
WHAT TO DO
In the event that the spark plugs become
soiled, clean them using a small, hard-
bristled brush (non-metallic).
The gas injector is located in the
depression in the centre of the burner.
Be sure not to block the injector during
cleaning, as this will affect hob
performance. Use a safety pin to unblock
the injector if necessary.
For tough stains, use a non-abrasive
cream, then rinse with clean water.
Carefully wipe each part of the burner
before using your hob again.
- Clean with warm water and then wipe.
For tough stains,
vitroceramic glass cleaning products.
PRODUCTS/ACCESSORIES
. Small, hard-bristled brush.
. Safety pin.
. Gentle scouring cream.
. Kitchen sponge.
- Cleaning sponge.
use special
- Special vitroceramic glass
products (e.g. Cera-Clean).
60
TO USE