De Dietrich DTG 1138 Serie Guide D'installation Et D'utilisation page 49

2 / INSTALLING YOUR APPLIANCE
CHANGING THE GAS SUPPLY
•
(CONTINUED)
Switching from butane/
•
propane gas to natural gas
For the 1-burner hob
(high-power burner)
C
HANGE THE INJECTORS
— Take off the grill, the cap, and the head of
the burner.
— Unscrew the central injector located at the
base of the burner unit Using a No.10 spanner,
(see A ) and using a No. 7 spanner, unscrew
the 3 injectors located around the central
injector (see B
— Replace with the new gas injectors; refer to
the injector positioning markers and the gas
settings table at the end of this chapter. The
new injectors should be fitted as follows:
— First, screw them in manually until hand
tight.
— Place the wrench on the injector.
— Turn the spanner clockwise.
— Replace the head of the burner, the cap and
the grill.
— Connect the power cable from your hob to
your single-phase mains supply (220-240 V
Refer to the section "Connecting to the
electricity supply".
Y
OUR HOB IS NOW READY TO BE USED WITH BUTANE/PROPANE.
, proceeding as follows:
) ( Fig.02).
A
B
Note
Screw on the injector with a torque not
exceeding 4 N.m.
Exceeding this limit may damage the
product..
Tip
).
- Each time you change the gas
~
supply, tick the box corresponding to the
gas level on the label found in the plastic
bag.
See "Connecting to gas the supply"
49
EN
Fig. 02