2/ Installing Your Appliance; Tips For Flush Mounting - De Dietrich DTI 1127 X Guide D'installation Et D'utilisation

2 2 / / INSTALLING YOUR APPLIANCE
EN

• TIPS FOR FLUSH MOUNTING

Model
Cabinet cut-out
Overall dimensions
above the work top
Overall dimensions
below the work top
Installation should only be undertaken by
qualified fitters and technicians.
Before installation, ensure that the
conditions of local distribution (gas type
and pressure) and the settings of the
appliance are compatible.
The setting conditions for this hob are printed
on a sticker inside the instruction guide
pouch and on the packaging.
As it is not connected to a system for
removing combustion by-products, it must be
installed in compliance
regulations and used in a well-ventilated area.
Special attention should be given to
ventilation regulations.
Width
56 cm
65 cm
55 cm
with current
44
Depth
49 cm
51.8 cm
47 cm
In this regard, as combustion can only take
place in the presence of the oxygen in the air,
the latter must be continually renewed and
combustion by-products
minimum flow rate of 2 m 3 /h per kW of gas
power is required.
Example:
- Total power = 0.85 + 1.5 + 2.25 + 3.1 = 7.7 kW.
7.7 kW x 2 = 15.4 m 3 /h minimum air flow.
These tables comply with the heating of
cabinets in accordance with standard
EN 60335-2-6 and class 3 as regards the
installation (in accordance with standard
EN 30-1-1).
Thickness
Depending on cabinet
5 cm
5. 1 cm
evacuated (a