Operating Safety - De Dietrich DTI 1127 X Guide D'installation Et D'utilisation

3 3 / / USING YOUR APPLIANCE
EN
•

OPERATING SAFETY

•
G
ENERAL STOP
— You can stop any gas burners currently
operating by pressing touch control
action cancels locking if this had been
programmed.
•
T
EMPERATURE LIMITER (MODEL
— Each cooking zone is equipped with a
safety sensor that constantly monitors the
temperature of the bottom of the cookware. If
you leave empty cookware on a zone which is
turned on, the power will be automatically
limited to prevent damage to the cookware or
hob.
•
P
ROTECTION AGAINST OVERFLOWS
— In case of overflow, or of a metallic object or
wet cloth placed on the control buttons, the
hob turns itself off, the displays light up and a
beep sounds. Clean the hob or remove the
object, then begin cooking again.
•
— Should you forget that cooking is in
. This progress,
automatically turn the hob off after a
predefined time (between 1 and 8 hours
depending on the power setting). "AS" is
DTI1127*)
displayed and a beep sounds for about
2 minutes. Press on the main selector touch
control to delete this information. A beep will
confirm your setting.
•
DTI1127*)
— If you place a small object on the area (a
ring, a fork, etc), the hob will detect it and not
deliver any power. The power display will flash.
Note: however, several small objects on the
cooking zone at the same time could be
identified as cookware. The hob will therefore
deliver power in this case.
metal objects such as knives, forks, spoons
and lids on the cooking surface, as they
may heat up.
62
A
UTO-STOP SYSTEM
this safety
"S
MALL OBJECTS" SAFETY
Note
— It is recommended to avoid placing
function will
DEVICE (MODEL