De Dietrich DTI 1127 X Guide D'installation Et D'utilisation page 49

2 2 / / INSTALLING YOUR APPLIANCE
Gas supplied by tank or
•
cylinder (butane/propane)
For your safety, you must choose from the
three following connection options:
— Use rigid copper pipe with screw-on
mechanical connectors (G1/2 gas standard
mark). Connect directly to the elbow joint
fitted on the appliance.
— Use a flexible metal hose (stainless steel)
with screw-on mechanical connectors
(compliant with the NF D 36-125 standard)
with an unlimited guarantee (Fig. 01).
A
Sealing washer (not provided)
B
Adaptor (not provided)
C
Hose clip (not provided)
Note
When connecting your hob's gas supply, if you have to change the direction of
the elbow fitted on the appliance:
① Unscrew the bolt whilst supporting the elbow ( ( F F i i g g . . 1 1 ) ) .
② Change the seal (supplied in the plastic bag).
③ Screw in the bolt holding the elbow in the intended position with a
torque not exceeding 17 N.m ( ( F F i i g g . . 2 2 ) ) .
Nut
Fig. 01
Elbow
— Use a reinforced rubber hose with screw-
on mechanical connectors (compliant with
the NF D 36-112 standard) with a 10-year
guarantee (Fig. 02).
In an existing system, a flexible pipe fitted
with hose clips (compliant with the XP D 36-
110 standard) with a 5-year guarantee may be
used. In this case an adaptor must be used
and a sealing washer must be inserted
between the adaptor and the elbow joint
(Fig. 03).
@ Q
Fig. 01
@ Q
49
Fig. 03
Fig. 02
Fig. 02
EN
A
B
C