De Dietrich DTI 1127 X Guide D'installation Et D'utilisation page 51

2 2 / / INSTALLING YOUR APPLIANCE
•
Electrical connection:
— Connect the power cable from your hob to
your single-phase mains supply (220-240 V
Refer to the section " Connecting to the
electricity supply ".
•
Check the type of gas supplied
— Select touch control
your finger on this control, press touch control
(Fig. 01).
An audible signal confirms your selection.
Within the following 5 seconds,
— Press touch control
An audible signal confirms your selection.
The back right zone display indicates the type
of gas selected.
"1 GAS"
F
OR NATURAL GAS
(Fig. 03)
"2 GAS"
F
OR BUTANE/PROPANE
(Fig. 04)
— To change the gas supply type, use the
"power slider", sliding your finger to the left or
to the right.
The gas supply
automatically after 5 seconds. (Fig. 05) .
Y
OUR HOB IS READY FOR USE.
~
. Whilst keeping
twice (Fig. 02).
type is confirmed
).
Fig. 01
Fig. 02
Fig. 03
Fig. 04
Fig. 05
51
EN