Trim Function For Forward/Reverse Driving; Trim Function Parts For Steering; Reverse Setting For The Drive Function; Reverse Setting For Steering - Reely TQ-Racer Notice D'emploi

c) Trim function for forward/reverse driving
If the vehicle does not come to a standstill when you release throttle/brake lever (2) for forwards/reverse driving
(centre/neutral position), adjust the trim for the drive function accordingly using the control dial "TH TRIM" (11) on the
transmitter.
Normally, the control dial is in the centre position (arrow on the control dial points to "0"). Due to the design,
a slight correction may be required so that the vehicle comes to a standstill when the throttle/brake lever
(2) is released.
It may also be the case that the motor emits quiet beeping noises (but the vehicle is stationary) when the
trim for the neutral position is not correctly set.
d) Trim function parts for steering
If the vehicle shows a tendency to pull towards the left or the right while it is being driven even though the steering
wheel is in the centre position, adjust the steering trim accordingly using the control dial "ST TRIM" (9) on the trans-
mitter.
Normally, the control dial is in the centre position (arrow on the control dial points to "0"). Due to the design,
a slight correction may be necessary to ensure that the vehicle drives in a straight line.
e) Reverse setting for the drive function
Usually, the vehicle will drive forwards when the throttle/brake lever on the transmitter is pulled towards the handle. If
the vehicle does exactly the opposite, move the "TH" reverse switch (7) to the other setting.
f) Reverse setting for steering
If you turn the steering wheel (1) to the left (anti-clockwise), the vehicle should turn to the left. If the vehicle does
exactly the opposite, move the "ST" reverse switch (6) to the other setting.
50