How To Start The Production Of Slush, Sherbets Or Cold Drinks With Fc Millennium - ELMECO First 1 Class Manuel Pour L'emploi Et L'entretien

Clean the tank as described in the manual on page 26; in order to stop the warning signal, press the
button; thus the countdown will start again for the next warning.
• Pressing on the
or
function. The function must be active (ON) ONLY if the First Class is equipped with autofill system
If you open the tank lifting the lid, the augers will stop.
Consult the Problem Solving Section page35.
All the functioning modes and the regulations set are registered in a non-volatile memory which is active even
without power; therefore, when you switch on the machine, the electronic board keeps the configuration it
had when you switched it off.
All machines are endowed with a probe that detects the product minimum level in the tanks. When the
product is below this level, for 20 minutes, the light of the lid starts blinking. If the product level does not
change, the light will stop blinking after a minute.
First Class Millennium is endowed with a direct signalling of the problems found. When the electronic board
blinks, it indicates that there is an active alarm. To see what alarm is, please press the
second. In the "Problem Solving" section, you can see a complete list of all possible alarms at page 35.
If more than one alarm is active, these will be indicated with more messages that appear alternatively.
How to start the production of slush, sherbets or cold drink with First Class
Clean the machine as described in the CLEANING paragraph.
Remove the covers and put the mix in the tanks.
Don't fill the tank with only water. In case of freezing product switch off the board until the product will
be liquid.
To prepare the product mix use only drinkable water.
The temperature of the poured product must not be lower than 10 °C in order to allow a correct
calibration of the electronic kit that will be indicated as described in the previous paragraph.
CLEANING
REQUIRED
AUTOFILL
ON/OFF
button it will be possible to activate (ON) or deactivate (OFF) the AUTOFILL
Operator security
Self-diagnostics
Configuration memory
Minimum level signal
Alarms functions
Millennium
- 31 -
button for 1