Illuminating Lamps Replacing; Fcw Installation - ELMECO First 1 Class Manuel Pour L'emploi Et L'entretien

Illuminating lamps replacing

In case of replacing of the lamp follow the procedure:
1. Switch off the machine;
2. Remove the complete lid from the transparent tank;
3. Separate the lid from the transparent lamp glass;
4. Change the old led lamp with new one supplied by the manufacturer;
5. Assembly the lid with the transparent lamp glass;
6. Reposition the complete lid on the transparent tank.
FCW installation (water cooling system)
If the First Class you bought is endowed with the water cooling system, it is
necessary to follow these instructions.
On the machine front side (outlet side) there are some water exit (left) and
entrance pipes (right) as shown in the pic. f.
The quantity of water necessary for the functioning can change according to
the product cooling phases, with higher values when starting the slush
production and values that are close to zero when you want to keep the
slush. We therefore recommend to connect the machine to the water
network with the maximum capacity, thus the pressure switch valve (pic. g)
in the machine will regulate the flux according the real necessity.
Important:
It is not possible to connect the FCW water entrance with the input of
another machine based on a water cooling system (series).
It is not possible to connect several machines based on the water cooling
system on the same outlet.
- 34 -