Old Machine Disposal; Technical Assistance; Illuminating Lamps Replacing; Fcw Installation - ELMECO First Class FC1 Manuel D'emploi Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The out-of-use machines must be disabled. Disconnect the plug from the electrical network and cut

the cable.

All refrigerating machines must be disposed by the communal disposal service or by an equivalent

private authorized company. Take care not to damage the rigid tubes of the refrigerator until they are

taken back in order to be carefully and ecologically disposed.

All packaging materials used can be disposed without any danger.

The repairing of the machine must be carried out by an authorized service centre, using only original

spare parts. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a hazard.

In case of replacing of the lamp follow the procedure:

Switch off the machine;

Remove the top light complete cover from the transparent tank;

Separate the top light from the transparent lamp glass;

Change the old illuminating lamp with new one (led lamp or in alternative12Vac -10watt);

Assembly the top light with the transparent lamp glass;

Reposition the top light complete cover on the transparent tank.

If the First Class you bought is endowed with the water cooling system, it is

necessary to follow these instructions.

On the machine front side (outlet side) there are some water exit (left) and

entrance pipes (right) as shown in the pic. f.

The quantity of water necessary for the functioning can change according to

the product cooling phases, with higher values when starting the slush

production and values that are close to zero when you want to keep the

slush. We therefore recommend to connect the machine to the water

network with the maximum capacity, thus the pressure switch valve (pic. g)

in the machine will regulate the flux according the real necessity.

Important:

It is not possible to connect the FCW water entrance with the input of

another machine based on a water cooling system (series).

It is not possible to connect several machines based on the water cooling

system on the same outlet.