Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
After the screen shown above the initial screen will be displayed:
Warning! The electronic board will keep the settings it had
when the machine was switched off.
When the tank is in stand-by mode, the augers and the cooling system
are off. The augers and the gear motor can be turned on by pressing the
button. The screen will show
If you press the
button, the screen will display as follows:
(where Y is a variable number between 2 and 5 for Cold Drink Mode,
which indicates the temperature in °C at which the product must be
prepared).
Using
and
you can increase or decrease the temperature of the
product. The recommended temperature is 4°C.
If you press the
button, the screen will display as follows:
(where X is a variable number between 1 and 9 and indicates the
density of the slush). If you use the
increase or decrease the slush density value.
Warning! If, when the electronic board is in Slush Mode, the product temperature is
greater than 5°C, the following screen will be:
This screen indicates that the calibration process is taking place. The
calibration process will take one minute to complete.
If you press the
button (Cooling off - cold drink - slush) you can
switch the machine functioning modes alternatively. Each time you press
the button, the different screens of cold drink – slush and cooling off alternate. In this latter position
only the augers rotate and no other action is taken.
If you press the auger rotation key
follows:
By holding the
selection menu.
Please note that unless you give any further instruction to the electronic
board in more 10 seconds time, the display will automatically go back to
the initial screen.
This screen allows you to turn ON or OFF the light in the lid, by pressing
the
and
buttons of the electronic
As you already know, for security reasons, when a tank is open, the
augers stop turning. However, the augers stop can be also caused by a malfunctioning of 1 and/or 2
contacts, or by the accidental lost of one of the contact during the
cleaning phase; in this case, it is possible to activate the electronic
bypass function. In this screen you can activate or deactivate the bypass
function by pressing the increase
This screen allows you to turn ON or OFF the Low Level control function
(automatic decrease of slush's density to no.1, when the level probe is
not covered with product for more than 20 minutes); you can do that by
and
buttons it is possible to
, the display will appear as
button for one second you will enter the
board.
and
decrease keys.
- 23 -
StandBy
Press
Motor On
Press < <> >
COLD
Y
SLUSH
*
X
SLUSH / SETTING / WAIT
*
X
StandBy
Press
LAMP
OFF / ON
ByPass
OFF / ON
LowLevel
OFF / ON
Publicité
Table des Matières
