Installation Of The Machine - ELMECO First 1 Class Manuel Pour L'emploi Et L'entretien

During maintenance and cleaning, or in case of bad
functioning, disconnect the machine from the power
plug by pulling the plug and not the cable (pic. 2 and
3).
Repairing must be made only by authorized and
skilled technicians. Reparations that are not state-of-
the art may be dangerous for the user. Please contact
our company to know the Authorized service center
closer to you.
Before installing the machine, verify that:
• The machine has not been damaged during transportation. In case of doubt,
contact the supplier;
• First Class is not placed by an heat source;
• The power supply system is endowed with a grounding that respects the rules of
law;
•
The power supply system capacity is adequate to the maximum power of the
machine, as indicated on the plate
In case of doubt, contact only qualified staff.
Carefully read the following instructions before installing the machine.
This machine must be used only for the purposes it was manufactured for. Any other use is to be considered as
dangerous.
It is suggested that the machine is installed only by qualified staff. A wrong installation can cause damage to
people or things, for which things the manufacturer declines any responsibility.
Once the machine is unpacked, verify the integrity of the machine. The packaging elements (plastic bags,
expanded polystyrene, nails, etc.) must not be left at children reach as they might be dangerous.
During transportation, do not lift machine by using the transparent tanks. Elmeco
will not be held responsible for the above mentioned wrong maneuvers.
Remove the protection plastic stripes also from the internal side of the grids.
Place the machine so as to avoid any heat source to be close to the grids. Verify that there is a free space of 25
cm (10 inches) at least around the machine (pic. 5 pag.82).
Place the machine on a counter that can bear its load.
We do not recommend to connect the machine through adaptors, multiple plugs and/or extensions. If
necessary, use only materials that conform to the safety rules in force, as for the current intensity up to what
indicated on the plate (pic. 4 pag.22).
After connecting the machine to the power supply and switching on the main switch, verify that air comes out
from the side grids (pic. 6 pag.82) and that the pressure switch light (pic. 29 pag.82) is on.
Warning! In normal operation, the pressure switch light must remain on. Turning off the light indicates
that the pressure switch has deactivated the cooling circuit. The pressure switch is equipped with

Installation of the machine

(pic. 4 pag.22).
Warnings
Installation
- 23 -