Installation Of The Machine - ELMECO QK 1 Manuel D'utilisation Et De Maintenance

During maintaining and
malfunctioning, disconnect the machine from the electric
network, by unplugging it - do not pull the wire but the
plug itself - (pict. 2 and 3).
Repairing must be made only by authorized and skilled
technicians. Reparations that are not state-of-the art may
be dangerous for the user. Please contact our company to
know the Authorized service center closer to you.
Before installing the machine, verify that:
The machine is not damaged during the transportation. In case of doubts consult your
vendor;
Quickream is located far from any heating source;
The power supply plant is endowed with a grounding system in accordance with
applicable law;
The electric capacity complies with the maximum power of the machine itself, as stated
in the plate
(picture 4 page 22).
If required by the local regulation, it is possible to have the appliance permanently
connected to the electrical power supply, ref. National Electrical Code (NEC) and NFPA
70. If this is the case, it is necessary to remove the side panel, disconnect the power
cable from the machine wiring, remove it from the machine and replace it with the
permanent cable by respecting the local codes.
If any doubt or concern, please only contact trained and authorized personnel.
Carefully read the following instructions before installing the machine.
This machine must be used only for the purposes it was manufactured for. Any other use is to be considered as
dangerous.
It is recommended that the installation is carried out by a skilled technician. The manufacturer will not be held
responsible under any circumstances for a wrong installation that could cause damage to people or things.
Once unpacked, verify that the machine is intact. The packing elements (plastic bags, expanded polystyrene, nails, etc.)
must not be left at children's reach as they can be dangerous.
During transportation, do not lift Quickream by using the transparent tanks. Elmeco
will not be held responsible for the above mentioned wrong maneuvers
Place the machine far from any heating source. Verify it has sufficient free space
(more or less 25 cm) around it.
Place the machine on a counter that can bear its load
cleaning, or in case

Installation of the machine

Installation
of
Warnings
.
- 23 -