Important Security Rules; Disposal Of The Old Machine; Technical Assistance - ELMECO QK 1 Manuel D'utilisation Et De Maintenance

•
When the product temperature reaches -3,5°C/25.7°F, the speed reduces to 50rpm. This is valid if the display still
reads "Soft Mode WAIT PLEASE";
•
When the temperature reaches -4,5°C/23.9°F, the speed decreases to 40rpm. This speed will be maintained even
if the display reads "Soft Mode READY TO SERVE" and will do so for the entire maintenance period of the
product. The same increases to 70rpm if the tank is dispensing. It will then return to 40rpm, 20 seconds after the
tap is closed.
During the "WAIT PLEASE" to "READY TO SERVE" phase the V3 speed predominates over the, V1 and V2
speeds. Therefore, if a specific product shows "READY TO SERVE" at -3,4°C/25.9°F, the velocity will reduce
from 70rpm to 40rpm, skipping the 50rpm stage.
•
If the electronic control panel does not detect any variations in product temperature for 10 minutes, then the
latter will be considered "READY TO SERVE". The electronic control unit will turn off and the solenoid valve will
come on, in order to maintain a constant tank temperature.
It is advisable to make sure the RTS TIME and EV OFF TIME are the same. In this way, the deactivation of
the solenoid valve will correspond with the passage from "WAIT PLEASE" to "READY TO SERVE".
Do not touch the machine with wet hands or feet.
Do not use the machine bare footed.
This appliance is not intended to be installed in kitchens.
Do not expose the machine to the weather.
Do not pull the power wire in order to disconnect the machine from the electrical network.
Do not remove the panels before disconnecting the machine from the electrical network.
Do not remove protections and / or covers that require the use of tools for their removal.
Discarded machine must be unusable. Unplug the machine and cut the power wire.
The refrigerators produced, like most other refrigeration, freezing and air-conditioners on the market, use Freon as
refrigerating gas. Freon, like other coolants, is a gas with a high environmental impact.
Even if the type of gas that the supplier uses for the production of its machinery is environmentally friendly (R290 -
Propano), the Company in question nonetheless requires purchasers to be aware of the following, from the time of
purchase, follow the reference standards.
All refrigerating machines must be disposed by the local administration service or by an equivalent private authorized
company.
Take care not to damage the rigid tubes of the refrigerator until they are taken back in order to be carefully and
ecologically disposed.
All packaging materials can be disposed without any danger.
Only an authorized service center can repair the machines (e.g. a power cord substitution) using original spare parts.
The out-of-use machines must be disabled. Disconnect the plug from the electrical network and cut the cable.
Warning! Any assistance work on machines loaded with R290 refrigerant must be performed by
knowledgeable and experienced person on the R290 gas management procedures. The activities must be
carried out by personnel designated by the manufacturer or the distributor who made the sale of the product

Important Security Rules

Disposal of the old machine

Ecological instruction

Technical assistance

- 34 -