ELMECO QK 1 Manuel D'utilisation Et De Maintenance page 28

- Remove the sleeve with star hole as illustrated in pic.10;
- Remove the hooks grips, if present;
- Open the hooks as illustrated in pic.11 and lift the tank as in pic.12-13;
- Remove the horizontal and vertical augers as shown in pic.14-15-16-17-18-19;
- Dip all parts in a solution of warm water and bleach (10 gr/litre of water);
- Prepare some other solution of warm water and bleach (10 gr/litre of water) and dip a cloth in it. This will be used
to clean the steel tank and the parts connected to it (pic.20);
- Wash with fresh water and dry all washed parts;
- Use a damp cloth to clean all the external parts;
- Reassemble the machine.
We recommend lubricating the points indicated in fig. 21 (auger mechanism and front side of the horizontal
auger) with food-grade Vaseline, to avoid any eventual noise (whistle) due to friction between the two plastic
elements.
- Connect the machine to the power supply.
On removing the piston from the container, carefully follow the steps in the images below to dismantle the shaft seal. The tool in the images is provided with the
Quickream machine.
After disassembly, wash the seal and the piston housing as described in the cleaning paragraph and reassemble the parts.
Disassembling the piston seal for cleaning
1
4
7
2
5
- 25 -
3
6