How To Produce Soft Ice Cream - ELMECO QK 1 Manuel D'utilisation Et De Maintenance

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

To prepare the product mix use only drinkable water.

Use UHT milk in the production of mix.

Don't fill the tank with only water. In case of freezing product switch off the board until the product will be

liquid.

Warning! If the mixture contains alcoholic product, consider that 15%, on total mixture, is the maximum value

that can come into contact with plastic parts.

If the horizontal auger is blocked because of ice blocks due to a lack of sugar or to other reasons, such as foreign

bodies in the tank, the augers can undergo a break.

If the product freeze completely turn off the machine, wait until the product becomes completely liquid, empty

the tank and check the cause of the problem (ie. Lack of sugar, failure to close solenoid valve, etc.).

The product must be maintained at a temperature not exceeding 5°C for periods specified by the manufacturer,

but for not more than 5 days. In case of failure of the refrigerator system the product should be inspected to

determine whether it has deteriorated.

Clean the machine as described in the "CLEANING" paragraph.

Turn off the main switch before filling the tank.

Remove the cover and pour the mix in the tank (max 4 liters - recommended 2,5/3 liters).

It is recommended to pour an already refrigerated product.

When switch on the machine (page22 pos.F), the following menu will be displayed

SoftPremiumCream

Rev. XX

Press the

key to start the augers rotation. The following menu is displayed

To stop the augers press the

By pressing the

button, you can select "SOFT MODE", "NIGHT MODE" or return to the "MOTOR ON" condition in

which the augers rotate. According to the display setting you can see

SOFT MODE

WAIT PLEASE

By setting "SOFT MODE" you will read "WAIT PLEASE" on the line below. This message indicates that the product is not

ready yet. In this condition the augers turn at 50rpm (default); this can be adjusted by changing the submenu settings in

the SERVICE section.

To view the menu options, press the

Use the

keys to find the TLI screen

Press the

button to confirm and view the TLI temperature that has been set on the electronic control panel.