How To Produce Slush, Sherbets Or Cold Drink - ELMECO B Large Manuel D'utilisation Et Entretien

If the LED blinks on the electronic board (1, 2, slush or cold drink), see the tables at the page 22, the Website "Problem
Solving" of
www.elmeco.com
All the functioning modes and the regulations set are registered in a non-volatile memory which is active even without
power; therefore, when you switch on the machine, the tank keeps the configuration it had when you switched it off.
The maximum amount of liquid that the tank can hold is (granita 7/7,5lt - creams 5/6lt).
To prepare the product mix use only drinkable water.
 Clean the machine as described in the previous paragraph.
 Remove the cover and pour the mix in the tank (max 7,5 liters).
Warning: The temperature of the poured product must not be lower than 5°C in order to allow a correct calibration
of the electronic board, this will be indicate with blink of led 3.
 When you switch on the machine (page14 pos.F) the electronic board will be set on the last stored mode. In the next
steps, it is assumed that when the machine turns on, the electronic board will be set with augers active and the
cooling system switched off.
Warning: Before turning on the switch, to make sure that the cover is placed on the transparent tank and it is
locked with the key.
 By pressing the mode selection button
lowest product density level. If the product temperature is higher than 5 °C, automatically, will start the calibration
procedure and the led "3" will blink. The blinking of led "3" will stop when the calibration procedure will be finished
(about 2 minutes), in this period of time the machine can work without any problem.
 If you press the mode selection button
the intermediate product density level.
 Pressing the mode selection button again
maximum product density level that can be set by B Large.
 If you press this button again
with a 4°C +/- 1°C temperature.
 If you press this button again
cooling system switched off.
 By pressing the button
Warning: If you press the button
board on stand-by.
, or call the service centre.
Configuration memory

How to produce slush, sherbets or cold drink

, you can set "slush" mode at the density "1" that's to say from the
twice, you change the "slush" mode to the density " 2" that's to say to
, you change the "slush" mode to the density "3" that's to say to the
, you pass to the "cold drink" mode; at this point, B Large will preserve the product
, you go back to the starting point, that's to say only with the augers active but the
the augers will be stopped.
, in any condition you are, the augers stops and places the electronic
Self diagnostics
- 19 -