Reely Stagger Notice D'emploi page 53

Assembly instructions, figure 37 (Q):
Use a double-sided adhesive tape to attach a suitable speed controller (not included) in front of the motor installed.
Use the included hook-and-loop straps to fix the rechargeable battery, guiding them through the corresponding open-
ings in the chassis pan.
Put the receiver you are using in the receiver box with foam inserts protecting it from vibrations while driving.
The cables between the receiver and the steering servo or speed controller are guided out of the receiver box on the
edge protected with a foam insert, just like the antenna (unless the receiver you are using has an integrated antenna).
All cables should be laid in such a way that they cannot get into moving drive parts. Fix the cables with cable fasteners.
Assembly instructions, figure 38 (R-1):
The lock for the roll cage must be attached as shown in the figure.
Important!
It is essential to ensure that the rotary knob and the lock are put together correctly; the flattened sides must
fit together, as shown in the detailed illustration.
Assembly instructions, figure 39 (R-2):
Secure the handle to the rotary knob with two M2.5 x 6 screws. Ensure the correct orientation in order to be able to
later swivel the handle by 90° between the two lock symbols on the plastic surface ("locked" or "unlocked"). More
information can be found in section 9. a).
Assembly instructions, figure 40 (S-1):
Use the two M2.5 x 15 screws to mount the two brackets on the front part of the roll cage.
Assembly instructions, figure 41 (S-2):
Assemble the roll cage. The two M2.5 x 12 screws are specially marked in the figure, since all other twelve screws
have the same size - M2 x 15.
Assembly instructions, figure 42 (S-3):
Secure the last part of the roll cage using two M2.5 x 15 screws.
Assembly instructions, figure 43 (T):
Mount the body parts on the roll cage. Make sure to use a washer for the two screws on the left and right at the rear
(the screws on the right-hand side are not shown, but must also be secured).
Assembly instructions, figure 44 (U-1):
The LED bar is already pre-assembled and its components are shown in figure 44.
53