Assembling The Model Vehicle - Reely Stagger Notice D'emploi

8. Assembling the model vehicle

You will need the following tools for assembly:
• Cross-head screwdriver, hexagon socket wrench and socket spanner in different sizes
• Needle-nose pliers
• Wire cutter
• Suitable gear grease
• Thread-locking fluid (medium strength)
Practical tips:
A suitable pad is also recommended for assembly. For example, you may use a universal car floor mat with
a grid, allowing optimal arrangement of screws, nuts and other small parts and preventing them from rolling
away.
The model is supplied in the form of pre-arranged assemblies with alphanumeric inscriptions.
Some larger bags (for example, bag A) include smaller bags with appropriate alphanumeric inscriptions, for example,
A-1 or A-1-1.
Important!
In addition to these operating instructions, refer to the separate assembly instructions. The procedure for
proper assembly of the model vehicle is shown in clear drawings. These assembly instructions also contain
additional information and practical tips for each assembly stage.
A sketch showing specially required screws/nuts etc. with their respective sizes can be found in the assembly instruc-
tions. The figure in brackets indicates the quantity of the respective parts. A label for the parts bag required for each
assembly stage can be found at the top right of the sketch drawings. To avoid confusion, only open the parts bag that
is needed for the assembly stage.
Then check the contents against the sketch and place the components and screws at the respective assembly sites.
Do not go to the next assembly stage and do not open another parts bag until you have assembled all parts from the
current assembly stage.
This procedure is the quickest way to assemble the model correctly.
Practical tips:
If the exact assembly of a component cannot be clearly identified from the current drawing, look at the
drawings below. The vehicle is often shown from different perspectives, which can make the assembly of
different components more clear.
If required, the assembly instructions can also be downloaded as a PDF in our online shop, either under
product or in the download centre. Pages can then be enlarged on a monitor and details can be seen more
clearly.
44