Driving The Vehicle - Reely Raven Notice D'emploi

c) Driving the vehicle
• Improper use can cause serious injury and damage to property! Only use the vehicle when it is within
your sight. Do not use the vehicle at night.
• Only use the vehicle when you are fully alert and able to respond. As is the case when driving a real
vehicle, fatigue, alcohol or medications can affect your ability to react.
• This model vehicle must not be used on public roads, spaces or paths. Do not use the vehicle on private
land without the landowner's permission.
• Do not drive towards people or animals!
• Avoid driving in very low outdoor temperatures. Plastic parts lose their elasticity in cold temperatures.
This can result in serious damage even after a minor accident.
• Do not use the vehicle during thunderstorms, under high-voltage power lines or next to radio masts.
• Always leave the transmitter turned on when the vehicle is in use.
• When you have finished using the vehicle, switch off the speed controller and fully disconnect the drive
battery from the speed controller.
Then turn off the transmitter.
• If the batteries (or rechargeable batteries) in the transmitter are weak, the transmission range decreases.
Replace the batteries or rechargeable batteries with new ones.
When the drive battery is nearly empty, the vehicle will slow down and may not respond properly to the
transmitter.
In addition to powering the motor via the speed controller, the drive battery also generates the necessary
voltage/current for the receiver and the steering servo.
This voltage is generated via an integrated BEC ("battery eliminator circuit", an electronic circuit that
supplies voltage directly to the receiver without an additional receiver rechargeable battery).
If the drive battery voltage is too low, the receiver voltage may drop and the vehicle may not respond to
transmitter commands.
If this occurs, stop driving the vehicle immediately (switch off the speed controller, disconnect the drive
battery from the vehicle and switch off the transmitter). Replace/recharge the drive battery as necessary.
• The motor, drive, speed controller and drive battery heat up during use. Take a break of at least 5–10
minutes before changing the rechargeable battery.
• Allow the drive battery to cool down completely before charging.
• Do not touch the motor, the speed controller or the rechargeable battery until they have cooled down.
Burn hazard!
33