Reely Stagger Notice D'emploi page 52

Assembly instructions, figure 32 (M):
Figure 32 shows the assembly of the receiver box. Use the two clips to seal the box cover. Screw the M3 x 3 set
screw into the socket of the antenna tube to secure the antenna tube (if the receiver you are using has a longer
antenna cable). The holder for the antenna tube is located on the right-hand side of the receiver box when viewed in
the direction of travel.
Assembly instructions, figure 33 (N-1):
With the motor plate (not included) attached to the motor, you can now mount the motor pinion on the motor shaft. Do
not fully tighten the M3 x 3 set screw yet, because you may still need to move the gear on the motor shaft so that it
runs exactly on the main gear.
Important!
When attaching and tightening down the motor pinion, make sure to screw in the set screw so that it rests
on the flattened side of the motor shaft.
Assembly instructions, figure 34 (N-2):
First, mount the fixing screw at the bottom of the motor plate and then install the upper screw. If necessary, move the
motor pinion on the motor shaft such that both gears are meshed throughout the width. Then securely tighten the
motor pinion.
Backlash adjustment is described in section 11. d) and must be carried out before the vehicle is used for
the first time.
Assembly instructions, figure 35 (O):
Screw two retaining screws for the gearbox cover into the corresponding holes in the chassis pan. The holes in the
top of the screw head must be parallel to the longitudinal axis of the vehicle (otherwise you will not be able to insert
the clips). Then put on the gearbox cover and secure with the two clips.
Clip two plastic clips onto the retaining screw in front of the upper suspension arm. Attaching the clips at the back
reduces the castor angle and thus compromises the directional stability.
Finally, screw four M3 x 3 set screws into the corresponding openings in the upper suspension arm holder. Make sure
that the four suspension arm screws are firmly tightened and cannot get loose.
For clarity, two detailed illustrations show the position in which the set screws must be screwed in.
Assembly instructions, figure 36 (P):
Mount the four tyres on the vehicle. As they have identical structure, their is no particular position in which they should
be mounted. When attaching the wheels, make sure that the hexagon on the inside of the rim rests exactly on the
wheel hub nut. Do not use excessive force when tightening the wheel nuts.
52