Sensor Recording (Svo-1520P Only) - Sony SVO-1320P Mode D'emploi

Sensor recording
(SVO-1520P only)
SENSOR REC indicator
SENSOR REC
REC LEVEL
TAPE SPEED
Notes
• If you insert a tape with its
safety tab removed, the
SENSOR REC indicator will
flash and the VCR will eject
it when you set the
SENSOR REC switch to
ON.
• If no cassette has been
inserted, the SENSOR REC
indicator will flash when
you set the SENSOR REC
switch to ON.
24 -EN
Additional Operations
The VCR can automatically start recording whenever a video signal is
input through the VIDEO IN jack.
1
Insert a tape with its safety tab in place.
2
Select the tape speed SP or LP with the TAPE SPEED
switch.
3
Check that the REC LEVEL control is set to the centre
position.
4
Set the SENSOR REC switch to ON.
The SENSOR REC indicator lights up, and the VCR turns off to
stand by for sensor recording.
5
Input a video signal through the VIDEO IN jack.
The VCR starts recording. When the tape reaches the end during
recording, the VCR stops recording and turns off.
If the video signal input stops, the VCR stops recording and
returns to the standby mode. The SENSOR REC indicator
remains lit.
To stop sensor recording
Set the SENSOR REC switch to OFF.
The VCR stops recording and turns off.
To cancel sensor recording
Set the SENSOR REC switch to OFF.