One Time Play - Sony SVO-1320P Mode D'emploi

Sequential play on two VCRs
(continued)

One time play

SEQ. PLAY indicator
SEQ. PLAY
Note
• The one time play does not
work if the SENSOR REC
switch is set to ON. (SVO-
1520P only)
22 -EN
Additional Operations
Tape conditions for sequential play
To use the sequential play function, the tape must meet the following
conditions:
• The blank portion at the beginning of the tape must be less than 25
seconds.
• There must be a blank portion of more than 5 seconds just after the
end of the recorded portion. If not, the VCR may continue to play the
next recorded portion or play to the end of the tape.
Beginning
blank
less than
25 sec.
To cancel sequential play
Set the SEQ. PLAY switch on each VCR to OFF.
Using one VCR, you can play back the desired portion of the tape once
and rewind the tape automatically to the beginning of that portion.
Use a tape that meets the conditions for sequential play.
1
Set the SEQ. PLAY switch to ON.
The SEQ. PLAY indicator lights up.
2
Insert a recorded tape into the VCR.
3
Press · PLAY to start playback.
· PLAY
Playback starts. When the tape reaches the end of the portion of
the tape to be played, the VCR rewinds the tape to the beginning
and stops.
To start playback again, press · PLAY.
To cancel one time play
Set the SEQ. PLAY switch to OFF.
blank
recorded portion
more than
five sec.
recorded
portion