Sony SVO-1320P Mode D'emploi page 27

TAPE SPEED
Tips
• To make your editing more
precise, use the pause
buttons on the VCRs.
• To cut out unwanted scenes
while editing, press
P PAUSE on the recording
VCR when an unwanted
event begins. When it ends,
press P PAUSE again to
resume recording.
Operation (when recording on this VCR)
Before you start editing
• Select the recording tape speed with the TAPE SPEED switch.
• Set the TV / VTR switch on the remote commander to VTR .
1
Insert a source tape into the other (playback) VCR.
r REC p STOP
P PAUSE
Search for the point to start playback and set it to
playback pause.
TV / VTR
2
Insert a tape with its safety tab in place into this
(recording) VCR. Search for the point to start recording
and press P PAUSE.
3
Press r REC on this VCR and set it to recording pause.
4
To start editing, press the P PAUSE buttons on both
VCRs to release the VCRs from pause.
For best results, press the pause button on the other VCR just
before pressing P PAUSE on this VCR.
To stop editing
Press the p STOP buttons on both VCRs.
Operation (when playing on this VCR)
Before you start editing
• Set the TV / VTR switch on the remote commander to VTR .
p STOP
1
Insert a source tape into this (playback) VCR. Search for
the point to start playback and press P PAUSE.
2
Insert a tape with its safety tab in place into the other
(recording) VCR. Search for the point to start recording
and set it to recording pause.
3
To start editing, press the P PAUSE buttons on both
VCRs to release the VCRs from pause.
For best results, press P PAUSE on this VCR just before pressing
the pause button on the other VCR .
To stop editing
Press the p STOP buttons on both VCRs.
Additional Operations
27 -EN