Sequential Play On Two Vcrs - Sony SVO-1320P Mode D'emploi

Sequential play on
two VCRs
* For the SVO-1320P, use an
audio cable for monaural
audio connection (not
supplied).
SEQ. PLAY indicator
SEQ. PLAY
Note
• The sequential play does
not work if the SENSOR
REC switch is set to ON.
(SVO-1520P only)
You can play the tapes inserted into two or more VCRs sequentially and
repeatedly if the VCRs are equipped with the SEQ. PLAY switch.
How to connect VCRs
CONTROL S
IN
CONTROL S
OUT
Operation
Before you start...
• Check that the SENSOR REC indicator is not lit. If it is lit, set the
SENSOR REC switch to OFF. (SVO-1520P only)
1
Set the SEQ. PLAY switch of each VCR to ON.
The SEQ. PLAY indicator on each VCR lights up.
· PLAY
2
Insert a recorded tape into each VCR.
3
Press · PLAY on VCR 1 to start playback.
You may press · PLAY on VCR 2 instead of VCR 1.
Playback starts on VCR 1. When the tape reaches the end of the
portion of the tape to be played, playback starts on VCR 2.
VCR 1 rewinds the tape to the beginning and stops.
When VCR 2 finishes playback, VCR 1 starts playback again.
This cycle is repeated.
To stop play
Press p STOP on the VCR being played.
VCR 1
VIDEO
AUDIO
CONTROL
OUT
OUT
S OUT
L/R
*
AUDIO
CONTROL
VIDEO IN
IN L/R
S IN
VIDEO
VCR 2
OUT
Additional Operations
(continued)
21 -EN