Integra Padgett S Guide De L'utilisateur page 23

APPENDIX (continued)
Guidance and manufacturer's declaration - electromagnetic immunity
The Integra Padgett Electric Slimline Dermatome Models S and S6 are intended for use in
the electromagnetic environment specified below. The customer or the user of the Integra
Padgett Electric Slimline Dermatome Models S and S6 should assure that they are being
used in such an environment
Immunity Test IEC 60601 test
level
Electrostatic ±6 kV contact
discharge, (ESD) ±8 kV air
IEC 61000-4-2
Electrical fast ± 2 kV for power
transient/burst supply lines
IEC 61000-4-4 ± 1 kV for input/
output lines
Surge ± 1 kV line(s) to
line(s)
IEC 61000-4-5 ± 2 kV line(s) to
earth
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
Voltage <5 % UT
dips, short for 0,5 cycle
interruptions
and voltage <40 % UT
variations on for 5 cycles
power supply
input lines IEC <70 % UT
61000-4-11 for 25 cycles
<5 % UT
for 5 sec
NOTE: UT is the a. c. mains voltage prior to application of the test level.
Compliance Electromagnetic Environment -
level Guidance
±6 kV Floors should be wood, concrete
±8 kV or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should be at
least 30 %.
±2 kV Mains power quality should be
that of a typical commercial or
±1 kV hospital environment.
±1 kV Mains power quality should be
that of a typical commercial or
±2 kV hospital environment.
3 A/m Power frequency magnetic fields
should be at levels characteristic
of a typical location in a
typical commercial or hospital
environment.
><5 % UT Mains power quality should be
for 0,5 cycle that of a typical commercial or
hospital environment. If the user
<40 % UT of the Integra Padgett Electric
for 5 cycles Slimline Dermatome Models S and
S6 requires continued operation
<70 % UT during power mains interruptions,
for 25 cycles it is recommended that the
Integra Padgett Electric Slimline
<5 % UT Dermatome Models S and S6 be
for 5 sec powered from an uniterruptible
power supply or a battery.
22