Ingersoll Rand X8I Mode D'emploi page 45

1 A
1 1
2 2
3 3
4 4
Diagnostics: XPM Expansion Module C:5-8
o only available when applicable EXP Expansion Box
is installed and registered (detected) by the X8I.
X8I Controller Diagnostics:
D1 Digital Input 1
D2 Digital Input 2
D3 Digital Input 3
D4 Digital Input 4
D5 Digital Input 5
D6 Digital Input 6
D7 Digital Input 7
D8 Digital Input 8
-------------------------------------------------------------
R1 Relay Output 1
R2 Relay Output 2
R3 Relay Output 3
R4 Relay Output 4
R5 Relay Output 5
R6 Relay Output 6
----------------------------------------------------------
Ao Analog Output 0.0 to 20.0mA
Digital Inputs:
OFF (open circuit)
ON (closed circuit)
Pulsing
5
4 A
1
2
ON
OFF
Pulsing
OFF
ON
Relay Outputs:
Each relay output can be energized and de-energized
manually by selecting the item. Use Up(plus) and
Down(minus) to adjust and Enter.
Ao: Analog Output:
The analog output can be manually adjusted. Press
Up(plus) and Down(Minus) to adjust and Enter. The
output will return to normal operational value upon
menu exit.
The analog output is utilized on the Terminal PCB to
switch the ir-PCB V outputs. Set the analog output to the
following to switch each 'V' output as required.
4.0mA All 'V' outputs OFF
7.0mA V1 = ON;
11.0mA V2 = ON;
15.0mA V3 = ON;
19.0mA V4 = ON;
45
V2, 3 and 4 = OFF
V1, 3 and 4 = OFF
V1, 2 and 4 = OFF
V1, 2 and 3 = OFF