Ingersoll Rand X8I Mode D'emploi page 4

ii. Attach a label to the isolator switch and to the
unit stating 'WORK IN PROGRESS - DO NOT
APPLY VOLTAGE' . Do not switch on electrical
power or attempt to start the X8I if such a
warning label is attached.
• Make sure that all instructions concerning operation
and maintenance are strictly followed and that
the complete unit, with all accessories and safety
devices, is kept in good working order.
• The accuracy of sensor devices must be checked
on a regular basis. They must be calibrated when
acceptable tolerances are exceeded. Always ensure
any pressure within the compressed air system is
safely vented to atmosphere before attempting to
remove or install a sensor device.
• The X8I must only be cleaned with a damp cloth,
using mild detergents if necessary. Avoid the use of
any substances containing corrosive acids or alkalis.
• Do not paint the control faceplate or obscure any
indicators, controls, instructions or warnings.
4