Ingersoll Rand X8I Mode D'emploi page 28

To select an item value or parameter for modification'
press ENTER; an adjustment screen for the item will be
displayed.
The value or option can now be modified by pressing
UP(Plus) or DOWN(Minus). To enter a modified value or
option in to memory press, ENTER.
Page 0
Item 1 Value
Item 2 Value
Item 3 Value
Item 4 Value
Item 5 Value
Item 6 Value
Press ESCAPE at any time in menu mode to step
backwards one stage in the navigation process. Pressing
ESCAPE when the page number is flashing will exit menu
mode and return the display to normal operational mode.
Page 0
Item 1
Item 2
Item 3
Item 4
Item 5
Item 6
All menu items have a unique reference consisting of the
menu page ID (a) and the menu page item number (b).
Each item in a menu also has a unique two alphanumeric
character code (c). All three references are visible at the
top of every menu item display.
1 2
Some menu items may consist of several individual
settings. Each setting of the menu item is also referenced
as a sub-item number. For example: P01-01.02 references
sub-item '02' of menu item '01' in menu page 'P01' . Sub-
item settings, where applicable, are always displayed
together on the same 'Item' adjustment display screen.
Most menu items are single value or single option only
in which case the single item is referenced as sub-item
number '01' (for example: P01-01.01).
Page 1
Page 2
Page 3
Page 4
Page 5
Page 1
Page 2
Value
Page 3
Value
Value
Page 4
Value
Value
Page 5
Value
A
Item 1 Value
Item 2 Value
Item 3 Value
Item 4 Value
Item 5 Value
Item 1 Value
Item 2 Value
Item 3 Value
Item 4 Value
Item 5 Value
Press and hold RESET for several seconds at any time
to immediately exit menu mode and return to the normal
operational display. Any value or option adjustment that
has not been confirmed and entered into memory will be
abandoned and the original setting maintained.
The X8I will retain an 'access code' for a short period
after menu exit allowing the menu structure to be re-
entered without the need to re-enter the access code
again. To immediately clear access code retention press
and hold RESET for several seconds.
A 'locked' symbol displayed with any item indicates
the item is locked and cannot be modified. This will occur
if the Item is view only (not adjustable) or in instances
where the item cannot be adjusted while the X8I is in an
operational state; stop the X8I first.
28