Utility Programmes - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

into two parts has been introduced to solve this
problem.
In this case, when the centred position is reached
and it becomes obvious that the balancing weight
will have to be applied in line with a spoke,
proceed as follows:
- Remain in the centred position.
- Select the
(displayed instead of the "select ALU pro-
grammes" icon).
- Select the spoke dimension on the displayed
window using the keypad: small, medium,
large or OFF (selection deactivated).
- Confirm by pressing the Kis knob or the
ENTER button.
- Apply two new counterweights in the posi-
tions indicated.
The weight division operations can be performed
on both balancing sides.
Static balancing
A wheel can be balanced using a single counter-
weight on one of its two sides or in the centre of
the well. in this case, the wheel is balanced stat-
ically. However, there is still the risk of dynamic
unbalance, which becomes more significant as
the width of the wheel increases.
Proceed as follows to balance motorcycle or car
wheels statically:
- Correctly set the wheel's geometric data as de-
scribed for the Dynamic balancing programme.
- Perform a spin.
- at the end of the spin, select the balancing
programme icon
knob or the ENTER button until the required
programme is selected.
The displayed image now shows only one pos-
ition search.
- Apply the balancing weight in the 12 o'clock
position on either the outer or inner side, or
at the centre of the rim well, indifferently. If
applied in the well, the weight is applied on
a diameter smaller than the rated diameter of
the rim. A value of 2 or 3 inches less than the
rated value must therefore be entered when
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Divide side weight icon
and press the Kis
the diameter is set in order to obtain correct
results.
Best results can be achieved if the weight is
divided into two parts to be applied on the two
sides of the rim.

UTILITY PROGRAMMES

The Utility programmes are all the functions of
the machine that are useful for its operation but
are not strictly connected to its normal operation.
Select the Utility and configuration programmes
icon to display the list (menu) of the utility
programmes .
Working environment program
This wheel balancer allows three operators to
work at the same time thanks to three different
working environments.
- Select the Working environments icon to call
up a different working environment.
- The following icons are displayed:
the lit icon shows the operator selected.
- Press the Kis knob or the ENTER button to
select the icon desired.
- Press the Exit button
setting and exit.
- The selection can also be seen in the working
screen status line.
By selecting a new operator, the machine resets
the parameters that were active at the last recall.
The stored parameters are:
- Balancing mode; dynamic, ALU, motorcycle,
etc.
- Wheel dimensions: distance, diameter and
width or those relating to the active ALU pro-
gramme.
- OPT: last OPT.
The machine's general settings remain the same
for all working environments: grams/ounces,
UK
to save the
71