General Notes On The Main Menu; Wheel Data Entry - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

GENERAL NOTES ON THE
MAIN MENU
Graphics are completely icon-based (drawings
and symbols that represent the function of the
button). If an icon is selected, the relevant func-
tion is activated.
Four icons can be found on the left part of the
monitor:
help;
highest accuracy;
utility and configuration programmes;
balancing programmes.
To select the icon desired, use the Kis or the
arrow keys until the icon desired is highlighted.
Make the selection by pressing the Kis knob or
the ENTER button.
The functions of every icon in the main menu
are listed below:
1. Balancing programs icon
; if called up, it groups the functions
relating to the balancing types.
2. The utility and configuration programmes
icon groups all utility and config-
uration programmes of the machine.
3. The highest accuracy
58
4. The help
By default the icons relating to points 3 and 4
are those described above but can be replaced
with more frequently used ones (refer to the
"Preferred programme configuration" section).
balancers without an ultrasonic
The machine allows for the diameter and distance
values to be entered automatically; the width
value can be entered using the keypad.
- Bring the automatic measuring arm into contact
with the inner side of the rim (fig.14). Take great
care to position the arm correctly so as to ensure
accurate data reading.
icon allows
EM 9580 Plus - EM 9580 C Plus - Operator's manual
balancing results to be displayed with best
possible accuracy ("G x1" or "Oz 1/10").
icon displays the inform-
ation relating to the current screen. If an
error message is displayed, the first piece of
information displayed concerns the type of
errors that may occur. The instructions called
up by this icon integrate (but do not replace)
this User Manual.

WHEEL DATA ENTRY

Wheel data entry for wheel
sensor
14