Optional Accessories; General Conditions Of Use; Switching On The Machine - Corghi LaserLine EM 9550 Manuel D'utilisation

OPTIONAL ACCESSORIES

Please refer to relevant accessories catalogue.
GENERAL CONDITIONS
OF USE
The equipment is intended for professional
use only.
WARNING
Only one operator at a time can work with the
machine.
The wheel balancers described in this manual
must be used exclusively to measure the extent
and position of car wheel unbalances, within the
limits specified in the Technical specification
section. Furthermore, models equipped with
motors must be provided with a suitable guard,
fitted with a safety device, which must be lowered
during the spin operation.
WARNING
Any use of the machine other than the de-
scribed use is to be considered as improper
and unreasonable.
CAUTION
Do not start the machine without the wheel
locking equipment.
WARNING
Do not use the machine without the guard and
do not tamper with the safety device.
CAUTION
Do not clean or wash the wheels mounted on the
machine with compressed air or jets of water.
WARNING
When working, never use equipment not manu-
factured by the manufacturer.
EM 9550 - Operator's manual
WARNING
Get to know your machine: The best way to
prevent accidents and obtain top performance
from the machine is to ensure that all operators
know how the machine works.
Learn the function and location of all the controls.
Carefully check that all controls on the machine
are working properly.
To prevent accidents and personal injury, all the
equipment must be correctly installed, correctly
operated and correctly serviced.
SWITCHING ON THE MA-
CHINE
Connect the power supply cable (A, fig.13) sup-
plied with the machine from the external electri-
cal panel located on the rear side of the wheel
balancer body to the mains.
A
Turn on the machine using the switch located
on the left-hand side of the body. (B, fig.13a).
B
UK
13
13a
51