Transport, Storage And Handling - Corghi LaserLine EM 9550 Manuel D'utilisation

TRANSPORT, STORAGE
AND HANDLING
The basic wheel balancer packaging consists
of 1 wooden crate containing:
- the wheel balancer (fig.11);
- the ultrasonic sensor (optional) and accessories
(B, fig.11);
- the wheel guard and its support (I, fig.11).
Before installation, the wheel balancer must be
shipped in its original packaging, making sure
that the machine is maintained in the position
indicated on the outer packaging. The machine can
be moved by placing the packaging on a wheeled
trolley or inserting the forks of a fork lift truck in
the relative slots in the pallet (Fig. 1).
- Packaging dimensions:
Length (mm/in) .......................................... 1410/56
Depth (mm/in) ........................................... 1380/54
Height (mm/in) .......................................... 1250/49
Weight (kg/lb) ............................................ 171/376
Packaging weight (kg/lb) .............................. 31/68
Weight of electrical/electronic
components, Std: ............................................. 5kg
Weight of the electrical/electronic components
with the automatic wheel clamping system: 7kg
- The machine must be stored in an environment
meeting the following requirements:
• relative humidity ranging from 20% to 95%;
• temperature ranging from -10° to +60°C.
CAUTION
Do not stack more than two packs to avoid
EM 9550 - Operator's manual
damaging them.
The machine may be moved for installation or
for subsequent relocation as follows:
- with a crane, using special equipment that holds
the machine at the designated lifting points (Fig.
2);
- by inserting the forks of a lift truck under the
machine so that the centre of the forks corre-
1
spond approximately to the centre line of the
body (Fig. 3).
2
UK
3
43