Transport, Storage And Handling - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

TRANSPORT,
STORAGE AND HANDLING
The basic wheel balancer packaging consists
of 1 wooden crate containing:
- The wheel balancer (fig. 11).
- the ultrasonic sensor (optional) and accessories
(B, fig.11);
- The wheel guard and corresponding support
(I, fig. 11).
Before installation, the wheel balancer must
be shipped in its original packing, making sure
that the machine is maintained in the position
indicated on the outer packing. The machine can
be moved by placing the packages on a wheeled
trolley or inserting the forks of a fork lift truck in
the relative openings in the pallet (fig. 1).
- Packaging dimensions:
Length (mm/in) ......................................... 1410/56
Depth (mm/in) .......................................... 1380/54
Height (mm/in) ......................................... 1250/49
Weight (kg/lb) ........................................... 171/376
Packaging weight (kg/lb) ............................. 31/68
- The machine must be stored in an environment
meeting the following requirements:
• Relative humidity ranging from 20% to 95%
• Temperature ranging from -10° to +60°C
48
Do not stack more than two packs to avoid
damaging them.
The machine may be moved for installation or
for subsequent relocation as follows:
- With a crane, using special equipment that
holds the machine at the designated lifting
points (fig. 2).
1
- By inserting the forks of a lift truck under the
machine so that the centre of the forks corres-
pond approximately to the centre line of the
body (fig. 3).
EM 9580 Plus - EM 9580 C Plus - Operator's manual
CAUTION
2
3