Switching On The Machine - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

SWITCHING ON THE
MACHINE
Connect the power supply cable (A, fig. 13)
supplied with the machine from the external
electrical panel located on the rear side of the
wheel balancer body to the mains.
Switch on the machine using the switch located
on the left side of the casing (B, fig. 13a).
EM 9580 Plus - EM 9580 C Plus - Operator's manual
12a
The wheel balancer performs a checking test and,
if no anomaly is detected, a beeper sounds and
the machine displays customisation data and
mark, then waits for the wheel's geometric data
to be entered.
Turning the Kis or by pressing the Kis knob or
the enter button or arrow, it is possible to display
the image of the unbalance value;
the initial active status will be:
- dynamic balancing mode;
- values displayed: 000 000;
- unbalance display at 5-g (or 1/4-of-an-ounce)
increments;
- sensor value rounding-off active;
- default geometric values:
width= 5.5", diameter = 14", distance = 150;
- operator 1 active.
Note: if the image is not centred on the LCD
monitor, adjust it using the controls located on
the front part of the monitor. For further inform-
13
ation on the adjustment procedure, refer to the
monitor manual provided, which can be found
inside the packaging.
Now the operator can set the data of the wheel
to be balanced or select one of the programmes
available.
13a
UK
57