Installation - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

WARNING
Always unplug the power supply cable from the
socket before moving the machine.
CAUTION
Never apply force to the wheel spin shaft when
moving the machine.

INSTALLATION

WARNING
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
positioning them as indicated on the packaging
and keep them intact so that the machine can
be safely shipped at a later date if necessary.
WARNING
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be installed
and used in protected environments where there
is no risk of dripping onto it.
The floor must be strong enough to support a
load equal to the weight of the equipment plus
the maximum load allowed. The support base on
the floor and the envisaged fixing means must
also be taken into account.
IMPORTANT:
For the correct and safe operation of the machine,
the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80%
(without condensation).
- Temperature ranging from 5° to +40°C.
EM 9580 Plus - EM 9580 C Plus - Operator's manual
CAUTION
For information concerning the technical fea-
tures, warnings and maintenance instructions
consult the related operator manuals provided
with the documentation of the machine.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the proced-
ures described below.
LCD monitor and relevant
support assembly instructions
- fix the monitor support (A, fig.4) to the weight
tray and to the casing using the six screws
supplied with the machine (fig.4);
- insert the signal cable (S, fig.5) and the power
supply cable (M, fig.5) for the monitor inside
the previously mounted support, as shown in
figure 5;
- fix the closing plate (A, fig.5) using the eight
screws (V, fig.5) supplied with the machine;
- Remove the monitor from its packaging and fix
it to the support flange using the four screws
provided with the machine (A, fig. 6).
- connect the signal cable and the power supply
cable to the rear monitor panel (B,C fig.6).
UK
4
49