Wheel Spin And Position Search - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

- : pressing the Kis knob enables the
manual entry of the width;
- Pressing the
ated phase returns to the working environment,
maintaining the previous width.
- in this phase, it is possible to perform a new
acquisition of the rim planes.
- lowering the guard confirms the selection that
was made (manual width entry or wheel type
selection) and the width scanning and spin are
performed.
Note:
- automatic width acquisition is re-enabled only
with a new acquisition of the automatic internal
measuring arm;
- if the wheel guard is closed or in the case of
a fault of the sensor located on the guard, the
machine will automatic setup for manual width
entry when the internal measuring arm is moved
to the rest position;
- at the end of the spin, it is possible to change the
width acquired automatically by the machine by
selecting the following icon on the work page
:
EM 9580 Plus - EM 9580 C Plus - Operator's manual
button during the indic-
IMPORTANT
bear in mind that the wheel's rated diameter
(e.g. 14") refers to the planes on which the tyre
beads rest, which are obviously inside the rim.
On the other hand, the data measured refer to
external planes, so they will be lower than the
rated values because of the thickness of the
rim. The correction value therefore refers to an
average thickness of the rim. This means that
the data measured on wheels with different
thicknesses may vary slightly (2 or 3 tenths of
an inch maximum) from the rated values. This is
not a lack of accuracy of the measuring devices,
but reflects reality.
If the automatic measuring arm fails to operate,
the geometric data can be entered manually by
following the procedure indicated in the "manual
wheel data entry" section, function present within
the utility and configuration programmes.
WHEEL SPIN AND
POSITION SEARCH
Wheel spins take place automatically by lowering
the guard or pressing the start button
with the guard lowered.
A special safety device stops rotation if the guard
is raised during the spin; in this case, the A Cr
message is displayed.
During position search, the wheel can rotate with
the guard raised. Every time the start button is
pressed , the centred position of one
side switches to the centred position of the other.
This function is active only if the RPA program is
set to ON (see "RPA - Automatic position search
configuration", function present in the configur-
ation programs).
WARNING
Do not operate the machine without the guard
and/or if the safety device has been tampered
with.
UK
61