Standard Accessories; Optional Accessories; General Conditions Of Use - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

STANDARD ACCESSORIES

The following parts are supplied together with the
machine.
Weight pliers
Calliper for wheel width measurement
Sliding flange holder kit
Calibration weight
Wheel balancer power supply cable
Monitor power supply cable
kit 4 cones
Wheel fixing cap protection
Spacer cap
Wheel fixing cap
C VERSION
C hub
C locking device
C hub key
STD VERSION
Threaded hub
Hexagon wrench, size 10
Wheel fixing quick ring nut

OPTIONAL ACCESSORIES

Please refer to relevant accessories catalogue.
GENERAL CONDITIONS
OF USE
The equipment is intended for professional
use only.
WARNING
Only one operator at a time can work with the
machine.
The wheel balancers described in this manual
must be used exclusively to measure the extent
and position of car wheel unbalances, within the
limits specified in the Technical specification
section. Furthermore, models equipped with
motors must be provided with a suitable guard,
fitted with a safety device, which must be lowered
during the spin operation.
WARNING
Any use of the machine other than the de-
scribed use is to be considered as improper
and unreasonable.
56
Do not start the machine without the wheel
locking equipment.
Do not use the machine without the guard and
do not tamper with the safety device.
Do not clean or wash the wheels mounted on the
machine with compressed air or jets of water.
Only original
recommended for use with the machine.
Get to know your machine: the best way to
prevent accidents and obtain top performance
from the machine is to ensure that all operators
know how the machine works.
Learn the function and location of all the
controls.
Carefully check that all controls on the machine
are working properly.
To prevent accidents and personal injury, all the
equipment must be correctly installed, correctly
operated and correctly serviced.
POSITION OF THE OPERATOR
In fig. 12a are the positions occupied by the op-
erator during the various work phases:
A Mounting / disassembling operations, launch,
dimension detection (where provided) and
wheel balancing
B Machine programs selection
In this way, the operator is able to perform,
monitor and verify the outcome of each wheel
balancing and intervene in case of unforeseen
events.
EM 9580 Plus - EM 9580 C Plus - Operator's manual
CAUTION
WARNING
CAUTION
WARNING
the manufacturer
WARNING
equipment is