Technical Data; Machine Dimensions; Working Range - Corghi EM 9580 Plus LaserLine Manuel D'utilisation

page.
- Independent working environments that allow a
maximum of three operators to work in parallel
with no need to reset any data.
- RPA: automatic wheel positioning in the position
where the balancing weight has to be applied.
- "Visual inspection" function that allows round-
ness defects of the wheel and rim to be visually
checked.
- Possibility to select the position for applying
the adhesive weight:
- Vertical plane in the lower part of the wheel
(H6) using the LASER line
- Vertical plane in the upper part of the wheel
(H12)
- CLIP: using the weight-holder terminal in the
ALUP balancing programmes (in all the other
H12 balancing programmes)

TECHNICAL DATA

Power supply voltage: ............. 1Ph 100-230V 50-60Hz
Rated current: .......................................................1.7-4A
Overall power: ....................................................... 400W
Balancing speed:......................................75-85-98 rpm
Maximum unbalance value calculated: ................999g
Average wheel spin time (with 5"x14" wheel): 5.5 sec.
Shaft diameter: .................................................... 40mm
Working environment temperature: ............. 5 to 40°C
WINUT Device Operating Frequency .............. 2.4GHz
Maximum power of radiofrequency signal ..... 100mW
Weight of the electrical/electronic component
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Std: .................................................................8,5 kg
Weight of the electrical/electronic component with
an automatic wheel clamping system:......10,5 kg

Machine dimensions

depth with guard closed ............................... 1377 mm
depth with guard open .................................... 894 mm
width with guard ............................................ 1453 mm
height with guard closed ............................... 1652 mm
height with guard open .................................. 1884 mm

Working range

automatic rim width...............................from 1.5" to 20"
manual rim width...................................from 1.5" to 25"
automatic rim diameter............................from 1" to 28"
rim diameter can be set manually..........from 1" to 35"
automatic max. wheel/machine distance .....................
...........................................................from 1 to 350 mm
max. wheel/machine distance can be set manually ...
.......................................................... from 1 to 500 mm
max. wheel width (with guard)...........................560 mm
max. wheel diameter (with guard)....................1118mm
maximum wheel weight..........................................75 kg
Machine weight (without accessories).................140 kg
Operating noise level.....................................<70 dB(A)
12
UK
55