Product Configuration Request Frame; Network Configuration Request Frame; Value Request Frame Of Specific Registers - ADEUNIS Sigfox Smart Building COMFORT Guide Utilisateur

Sigfox Smart Building COMFORT - Guide utilisateur / User guide version V1.0.1
E.g.:
• The product is running in the periodic mode
O S301 = 6 i.e. a periodicity of sending of frames of 60min, every hour or 24 times per day.
O S307 = 4, we wish to perform 4 downlink frames per day
O Result: The value of S301 gives us 24 frames per day that are divided by the value of S307 to obtain the result of 6. Thus for all 6 Periodic
frames the acknowledgment request will be transmitted thus enabling the network to send a downlink frame.
• The product is running in the event mode
O S300 = 36 i.e. a periodicity of sending of frames of 360min, i.e. Every 6 hours or 4 times per day.
O Result: the acknowledgment request will be transmitted 4 times per day thus enabling the network to send a downlink frame.
Caution: The configuration of the downlink frames has impacts on consumption and therefore on the life of the product since it must then open
listening windows and no longer be in standby. On the other hand, as the SIGFOX network limits to 4 the number of downlink frames if the
product configuration allows us to do a lot more, there will be no more response from the network and the acknowledgment that the product is
waiting for will not come.

4.2.1 Product configuration request frame

This frame allows to inform the product via the network that it must resend the product configuration uplink frame (0x10).
0 1
Code
0x01 X

4.2.2 Network configuration request frame

This frame allows to inform the product via the network that it must resend the network configuration uplink frame (0x20).
0 1
Code
0x02 X

4.2.3 Value request frame of specific registers

This frame (0x40) makes it possible to inform the product via the network that it must transmit the values of the registers requested.
Frame 0x40:
0 1
Code
0x40 CONF ID 1
Description of the frame:
Bytes 1 to n: CONF ID X (8 bits): index of the register to send. The corresponding register is 300 + CONF ID X value.
For example, if CONF ID 1 = 0x14 (20 decimal), the transmitter will return the S320 register value.
The associated uplink is code 0x31 (see section 4.1.5 for details).
IMPORTANT: the user can specify several CONF IDs in his downlink frame but it is up to him to verify that according to the protocol, the size of
the data available in a downlink will be large enough to contain all the desired data. Otherwise, the application will send only the first values.
2 3
X X
2 3
X X
2 3
CONF ID 2 CONF ID 3
DISTRIBUTED BY TEXIM EUROPE
4 5
PAYLOAD
X X
4 5
PAYLOAD
X X
4 5
PAYLOAD
X X
FR
EN
6 7
X X
6 7
X X
... n
X CONF ID n
Page 75 of 85